High Lifter Signature Series 3" Lift Kit for Polaris Ranger 500/700/800 EFI Ranger
Note: This product has replaced lift kit PLK700R-01.
Bigger. Badder. BOLDER. Take your ATV to the edge with High Lifter’s 3” Signature Series Lift Kit. Increase your ground clearance and make room for larger tires to dig deep and ride hard in most any terrain. Our engineers and staff have spent over 15 years perfecting the ultimate ATV lift kit. The product? An easy-to-install, bolt-on lift that consistently measures truer over competitor products.
The High Lifter 3” Lift Kit relocates the shock mounts to provide additional lift making room for larger tires and tightens suspension. Each Lift Kit part is precision cut and zinc plated for durability and reliability in any environment.
This kit contains alignment cones for 10mm bolts for use with factory tie rod/rod ends and OEM bolts If you have upgraded or plan to upgrade to our Pro Series Tie Rod/Rack End kit, see notes below.
3” Lift Kit Features:
- All hardware needed for successful installation
- User-friendly instructions
- Bolt-on application; takes approximately 1-2 hours for install
- Zinc plated
- Front and rear lift
- Clear-coated High Lifter name plate
Polaris 800 EFI Ranger XP, HD IRS - Up to 28"
Polaris 800 Ranger Crew IRS - Up to 28"
Our stated tire fitment guide is a general fitment and is in no way guaranteed. Tires and lifts vary by manufacture and tire fitment can be affected by other modifications. Always verify your brand of tires, lift, and other modifications prior to making a buying decision.
Polaris 500 EFI Ranger (09-10)
Polaris 700 EFI Ranger XP & HD IRS (2009; will not fit 2009 700 Crew)
Polaris 800 EFI Ranger XP, HD IRS (10-13)
Polaris 800 Ranger Crew IRS (10-14)
1.5" spacers are recommended, but a MINIMUM of a 1" wheel spacer is required on the front if you are running 12" diameter factory or aftermarket wheels for the wheel to clear the tie rod with the alignment cones installed. If you are running wide tires a 1.5" or wider spacer may be required depending on the width of the tire for tire to shock clearance at full lock steering.
New Rear High Lifter Outlaw DHT Axles, High Lifter Pro Series Axles, or Gorilla CV Axles are recommended for the 2011-2014 Ranger models before installing ANY brand of lift kit. The 2011-2014 model rangers have lighter duty rear axles than previous year models and are more prone to breakage.
|Vehicle Model(Shop by Vehicle)||Ranger Fullsize 500/800 (2009-2014)|